One, remote controller ID piles up an input
Most importable code of 4 remote controller ID. If ID piles up reintroduce remote controller,will keep clear of all ID codes that input before. Accordingly, when undertaking ID piles up an input to operate, should to the car advocate ask for all remote controllers.
When undertaking ID piles up an input to operate. Must reach following signal input muti_function remote control is unit.
● of power source of accumulator of ● of ignition switch ON comes from remote controller signal
2, ID code inputs concrete step:
1. activation registers mode
(1) car must pass the following two kinds of means open a lock: Remote controller or come from lock of car guard against theft to stop of the system transmit respondent OK signal.
Affirm the following respects above all: ① affirms all door open a lock. ② affirms all remote controllers that already registered. ③ affirms the batteries of all remote controllers is regular. ④ affirms to there is transmit source all round car. ⑤ affirms the accumulator job of car is regular.
(2) is inside 10s, turn ignition switch well and truly to ON position 6 times from LOCK, turn ignition switch to LOCK position next (the key maintains in ignition key) .
(3)2s hind registers mode activation, turn to the lamp to will twinkle 2 times (if mode activation is registered after 2s, turn to the lamp to did not twinkle, from (2) measure activations afresh) .
(If 4) registers the condition that mode works after 2s: ② of; of position of N of 騉 of of cut down of of vulgar Qian Li has registered ③ of; of 4 remote controllers to did not receive remote controller or ignition switch signal inside 120s.
2. registers mode
(1) the UNLOCK that presses a remote controller (open a lock) pushbutton.
(2) press LOCK (closedown) pushbutton 3.
(3) loose UNLOCK (open a lock) pushbutton.
(4) if register code of remote controller ID correctly, turn to the lamp to will twinkle 1 times (turn to the lamp to did not twinkle 1 times, from (1) measure is registered afresh) .
(5) if register code of remote controller ID correctly, turn to the lamp to will twinkle 1 times, continue to register mode.
(6) after registering needs remote controller, change ignition switch to ON the position, in order to affirm ID is piled up.
(7) if on the rails the enrollment of the remote controller is operated, turn to the lamp to will twinkle 2 times (if normal ground undertook the enrollment of the remote controller is operated, turn to the lamp to did not twinkle, register mode to begin to register from activation afresh) .
(8) if normal ground undertook the enrollment of the remote controller,operate, turn to the lamp to will twinkle 2 times.
(9) move ignition key from inside ignition switch, use each remote controller to undertake closedown is mixed lock operation, in order to affirm the function of all remote controllers
Previous12 Next
